QR code not scanning? Seven fixes
Why a printed QR code won't scan and how to fix it: size and distance, glare, contrast, printer scaling, the quiet zone, light and the camera's QR setting.
A QR code that will not scan is nearly always a printing or placement problem, not a problem with the code. Work through these fixes in order. Most people find the cause in the first three.
1. Make it bigger, or stand closer
As a rule of thumb, a phone reads a code from about ten times its width. A code 7 cm across, like the one on Keepsake's A5 card, reads from about 70 cm away. A code 15 cm across reads from about a metre and a half. If guests have to scan from across a table or a room, print the code larger, or move the sign to where they can get close.
Very small codes are also hard to read up close, because the camera struggles to focus. As a rule of thumb, avoid printing a code smaller than about 3 cm across.
2. Get rid of glare
Laminate, gloss paper, acrylic and frame glass all reflect light. A bright spot over part of the code hides it from the camera. Tilt the sign, move it away from downlights, or print on matte paper. If you need to protect a sign, a matte laminating pouch reflects much less than a glossy one.
3. Check the contrast
Cameras look for dark squares on a light background. A dark code on white or cream paper works best. Pale codes, codes on patterned or dark backgrounds, and light-on-dark codes are all less reliable, especially in dim light. Keepsake's signs print the code dark on a light panel, so keep it that way even if you change the accent colour.
4. Turn off "scale to fit"
Many printers and print dialogs shrink a page slightly to fit the paper's margins. That makes the code smaller than you expect, and with it the distance it reads from. Print at 100% or "actual size", then measure the code with a ruler. If you are using a print shop, ask them to print at actual size, not fitted to the page.
5. Leave the quiet zone clear
A QR code needs a clear border of plain background around it, called the quiet zone. If it is trimmed off by a guillotine, covered by a frame's edge, or crowded by a border or decoration, scanners can fail. Leave a margin of plain paper on every side, and don't let stickers, flowers or table numbers overlap the code.
6. Add light
A phone camera needs some light to see the code. In a dark room, or when the lights go down for dancing, codes become hard to read. Place at least one sign near a lamp, the bar or a candle that lights it evenly. Guests can also turn on their phone's torch, though on glossy paper that can cause glare of its own.
7. Check the phone's camera settings
Most phones read QR codes in the standard camera app: point it at the code and a link appears. On some phones, QR scanning is a setting in the camera app that can be switched off. If one guest's phone will not react while others work, that is the likely cause. They can switch it on in the camera settings, or try another phone at the table.
A dirty lens can also stop a scan. A quick wipe of the camera on a sleeve is worth a try.
If all else fails: type the address
Keepsake can print the guest book's web address in small type under the code. Anyone who cannot scan can type it into their phone's browser and reach the same page. Leave this option on in the sign designer, so nobody is stuck.
Test before you print the lot
Print one sign, scan it with two or three different phones from where guests will stand, in light like the venue's. Only then print the rest. It is far easier to fix one sign than forty table cards. The checklist in test it before the day walks through the rest.
Keepsake's sign designer gives you table cards and a welcome sign with the code at a size that reads well. See QR code signs for your guest book.